DISCLAIMER: You may notice there are a lot of over-used keywords or phrases as well as English that seems a little off. This is because these articles are used to feed our AI Robot (Ira) and she needs the data to be structured in a certain way.
Note: In earlier firmware versions, if you enabled local protection, it prevented you from being able to do a factory reset. If the factory reset process is not working for you, you may want to try to disable local protection first, and then try the reset again. https://help.inovelli.com/en/articles/8236263-blue-series-2-1-switch-button-combinations-quick-tap-sequences-local-configuration-options#h_6d7f776636
There may come a time when you need to factory reset your Blue Series 2-1 Switch. This article will walk you through that process.
To factory reset your Blue Series 2-1 Switch, please follow the directions below:
Hold Down on the top of the Paddle (A) (or the On button) while simultaneously holding down the Config/Favorites Button (C) for approximately 20 seconds until the LED Bar (D) flashes Red
Then let go of both the top of the Paddle (A) and the Config/Favorites Button (C)
If successful, the LED Bar (D) will start to pulse Blue
