All Collections
Blue Series • Updating Your Firmware • Hubitat
Blue Series • Updating Your Firmware • Hubitat
Eric Maycock avatar
Written by Eric Maycock
Updated over a week ago

NOTE: This procedure can be used for any of our Blue Series devices.

Make sure you have a recent version of Hubitat. If you don't see the same interface as below it is likely you need to update your system.

  1. Navigate to the device in your Hubitat control panel. Click on the Inovelli device that you would like to update.

  2. Scroll down on the device page until you see the "Update Firmware" button.

  3. Click on "OK" to accept the update prompt.

  4. That is it! You can watch the log or watch the device's LEDs to see the progress of the update.

Note: After the update is complete, the new firmware version will not show in the State Variables section until you hit the "Refresh" button on the device page, wait a few seconds, and then refresh the browser window.

Did this answer your question?