Skip to main content
All CollectionsOther / AccessoriesGen 1 - Dimmer Smart PlugResources
Gen 1 Dimmer Smart Plug w/Scenes • Quick Tap Sequences
Gen 1 Dimmer Smart Plug w/Scenes • Quick Tap Sequences

Quick taps to change settings and parameters locally on your Gen 1 Dimmer Smart Plug (NZW39)

Eric Hines avatar
Written by Eric Hines
Updated over a week ago

DISCLAIMER: You may notice there are a lot of over-used keywords or phrases as well as English that seems a little off. This is because these articles are used to feed our AI Robot (Ira) and she needs the data to be structured in a certain way.

Button Combinations

The Gen 1 Dimmer Smart Plug w/Scenes has many different button combinations that indicate what the switch is doing or what settings and parameters are being changed.

Quick Tap Sequences is a quick and easy way to change the important parameters (ie: change LED status indicator or invert switch).

Quick Tap Sequences

The Gen 1 Dimmer Smart Plug w/Scenes has various settings and parameters you can change at the switch itself via a sequence of taps at the paddle.

To see the table, click here: Quick Tap Sequences Table

Example: If you'd like to change the LED Indicator status on your Gen 1 Dimmer Smart Plug w/Scenes, you would hold the On/Off button for 5 seconds.

Change LED Indicator Light Behavior

To change the way the LED Indicator light behaves when turning on/off the smart plug, hold down on the on/off button for 5 seconds. There are two different options:

  • Smart Plug On = LED Off

  • Smart Plug On = LED On

Each time you hold down on the on/off button for 5 seconds, it will cycle through the two options above.

Disable the LED Indicator Light

To disable LED Indicator light on your smart plug, hold down on the on/off button for 10 seconds. Each time you hold down on the on/off button for 10 seconds, it will enable and disable the LED Indicator light.


Gen 1 Dimmer Smart Plug Button Combination Table

Below you'll find tables for the Quick Tap Sequences.

Quick Tap Sequences Table

Here's how you read this chart:

  • Look for the desired outcome you want

  • Follow the Action at your switch

Example: If you'd like to change the LED Indicator status on your Gen 1 Dimmer Smart Plug w/Scenes, you would hold the Dimmer button for 5 seconds.

Desired Outcome

Firmware Version

Action

Change LED Indicator Light Behavior

All

Hold down on the on/off button for 5 seconds. Each time this is done, it will cycle between the various LED Indicator Modes.

Disable LED Indicator Light

All

Hold down on the on/off button for 10 seconds. Each time this is done, it will turn the LED Indicator light on or off.

Did this answer your question?