IMPORTANT: Before installing your fan switch, please ensure the fan motor is set to high speed. If you notice that after you install your fan switch the speeds are not as fast as they were prior to installing your switch, it's likely that the motor was not on high (please adjust if you find this is the case).
In addition, if you have your switch controlling two fans, then the low and medium speeds will be half of what they were before.
Finally, if you are using this without a neutral wire, then you will only have low and medium speeds available.
REMINDER: This switch is only to be used to control AC Motor exhaust and ceiling fans. Do not use the switches on any sort of lighting load or DC Motor.
NOTICE: If you're having trouble pairing, please ensure the following:
Matter Devices and Controllers Must Be on the Same L2 Network
VLAN Use Requires Matter Controller/Server to operate on that VLAN
IPv6 Networking is Required for Matter Networks. Link-Local Addresses Are Allowed, Look for a Setting in your Router Called “Enable IPv6.” (Note: This does not require you to configure the IPv6 connection for your entire network)
Currently the Hubitat integration has been provided by a community member. With the drivers installed most of the device functionality is available! Scene support should be available once Hubitat updates their firmware to version 2.4.0.
Please follow the link for the files and instructions on how to get everything working.